High Flow Cam Support Plates Support Plate, Cam Tc

487,66 € *

inkl. MwSt. zzgl. Versandkosten

Lieferzeit ca. 1-2 Werktage

Artikel-Nr.: DS-0920-0006

Feuling? HIGH FLOW cam plates for T/C? engines increase engine oil flow and volume by enlarging... mehr

Menü schließen

Produktinformationen "High Flow Cam Support Plates Support Plate, Cam Tc"

Feuling? HIGH FLOW cam plates for T/C? engines increase engine oil flow and volume by enlarging the oil pump reservoirs and critical oil passages including matching the oil port holes throughout the cam plate to the port holes in the engine case increasin
Made from 7075 billet aluminum, which is 50% harder and stronger than the factory, SE? and other aftermarket cam plates. The 7075 increases the strength and hardness of the cam plate, holding tighter tolerances under temperature, eliminating flexing and t
Feuling? cam plates are blueprinted and matched to the Feuling? oil pumps, which allow the Twin Cam? engine to take full advantage of the increased volume from the high-flow oil pumps resulting in cooler quieter engine operation
Tighter cam bearing bore tolerance for improved press fit
Cam plates are pressure-tested & pressure relief valve and spring are pre-set and designed for the increased volume and pressure, eliminating the need to stretch the spring or use a shim
When matched with the Feuling? Race Series Oil Pump, rear wheel power gains of 3 Horsepower and 4 ft/lbs of Torque are achieved
For use ONLY with the Feuling? oil pumps
Bolts into stock location
CAM PLATE PART #0920-0006 includes military spec, hard anodized, bearing retainer plate and hardware; use Feuling oil pump PART #s 0932-0018 and 0932-0020
CAM PLATE PART #0925-0109 includes military spec, hard anodized, bearing retainer plate, tensioner pins and chain guide tower; use Feuling oil pump PART #s 0932-0018 and 0932-0020
CAM PLATE PART #0925-0110 features tighter cam journal bore tolerance for improved cam fitment, added cam journal oil groove for cold start-up protection and increased cam journal lubrication and added oil pressure feed holes to front and back of cam jour
CONVERSION CAM PLATE PART Part # 0925-0440 for T/C? 99-06, except 06 Dyna ? has the original style 99?06 Twin Cam? cam bearing bores for use with the press in bearings. This cam plate is designed to use the new style 07?14 Factory hydraulic chain tension
Made in the U.S.A.
NOTE: For use ONLY with Feuling? oil pumps; see page ???.

Weiterführende Links zu "High Flow Cam Support Plates Support Plate, Cam Tc"

Du willst wirklich schon gehen?